|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
 ;
You can fully trust on this one!
All the schematics are very crear an in one piece per page
;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
;
Thanks for a very good and readable servicemanual. Just what I needed as a "dinosaur technician". I really recommmend this site and will come back.
Åsbjörn
;
The manual I purchased was just what I needed. I was glad to find a site where I can find so many manuals on a wide variety of products.
2-7. PICTURE TUBE REMOVAL Note:
� Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom right and left.
� REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
� REMOVING PROCEDURES
!¢ Cushion
a
!£ Demagnetic coil
!� Holder DGC
a
!� Chassis assy 4 Two screws (washer head) (+P 4 � 16)
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
b b
!¡ CV board 9 Tension spring 7 Two screws (Tapping 7+ Crown Washer) PWB Bracket
!º Deflection yoke 5 Speaker (15 � 6.5cm) 6 Two screws (Tapping 7+ Crown Washer)
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
c
� 11 �
Coating earth assy 8 Anode cap
CRT Support Block
Screw Location 2 screws (+BVTP 4 � 16) 2 Two screws (washer head) (+P 4 � 16)
Anode Button
Beznet Hook
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c. 1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
�
HOW TO HANDLE AN ANODE-CAP
!§ Picture tube 1 Cushion
3 Speaker (15 � 6.5cm)
CRT Support Block
KV-HA21P50
RM-969
|
|
|
> |
|
