|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A great copy of the manual, and the only one I could find anywhere on the net! The circuit diagrams are easily readable, all component values marked and easy to see. A highly appreciated download!
 ;
Great Manual. This manual is available no where else. It was exactly what I was looking for.
;
The TEAC A-1500's Service Manual was instrumental in reviving this classic reel-to-reel. Not only does it have the schematics, exploded parts diagram and parts list, it also provided mechanical adjustment information that approximate factory default settings.
;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
;
Complete manual, the good quality of reproduction allows enlarged print-out of the schematic diagram in the size it probably had in the original print edition and which is necessary for practical use.
2-7. PICTURE TUBE REMOVAL
3 C board
b
6 VM board 4 Deflection yoke 2 A board 5 Four screws (Tapping screws)
b
2 Using a thumb press down, then pull up the rubber cap firmly in the direction indicated by the arrow b.
c
1 Anode cap
� 13 �
Cushion
Anode button
3 When one side of the rubber cap is separated from the anode button, the anodecap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c.
� REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CR T shield or carbon paint on the CR T.
�
HOW TO HANDLE AN ANODE-CAP
� REMOVING PROCEDURES
1 Do not damage the surface of anode-cap with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
KV-J51PF1S/J51PN1/J51PN21
a
a
1 Turn up one side of the rubber cap in the direction indicated by the arrow a. RM-869E
|
|
|
> |
|
