|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
reasonable price for the schematic - the service is perfect, all as expected and pointed by instructions - good scan of the original plans - thank you!
;
Manual was just as described!!! I odered it and in less than a day was able to download it and the text was clear and pages were all complete just as the original manual was. Purcashed this for a friend and they were more than happy. Perfect all around!
 ;
Excellent service and prompt delivery. But it's not a manual - only 4 pages wiring diagrams.
Thanks.
;
The manual I purchased was exactly what I needed to repair my Toshica television. The manual contained schematics and troubleshooting information that was very helpful.
;
Il download del Service Manual JVC HR 4100 non é stato eseguito
2-7. PICTURE TUBE REMOVAL Note:
� Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom right and left.
� REMOVAL OF ANODE-CAP
NOTE : � The picture tube is upside down, and the position for the anode cap and tension springs are changed accordingly. � Please remove necessary CRT support located on top left, top right, bottom left, bottom right, prior to removing the CRT.
!� Cushion (50x550) DGC 8 Demagnetic coil !¡ Holder DGC
� REMOVING PROCEDURES
a
!£ Cushion (35x250) DGC
a
7 Chassis assy 4 Four screws (washer head) (BVTP 3 � 12) 2 CV board 5 Deflection yoke 6 Tension spring 9 Two screws (Tapping 5 + Crown Washer)
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
A Board
b b
11 �
3 Speaker (5 � 9cm) !º Two screws (Tapping 5+ Crown Washer)
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
c
1 Anode cap
Anode Button
Coating earth assy Screw Location
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c. 1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
�
HOW TO HANDLE AN ANODE-CAP
CRT Support Block !� Picture tube !¢ Cushion
CRT Support Block
Slim Beznet
KV-PG21M10
RM-952
|
|
|
> |
|
