|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Clear and complete service manual. Easy now to restore my old Kenwood KD-1500.
Thanks a lot.
;
Thanks for this "hard to find" service manual. This Sony PS212A is a very good turntable that needed to be restored !
 ;
Excellent quality on these manuals. Same as having the original printed manual and incredibly useful when doing a custom install like me. Keep it up on the good work.
;
This is an excellent information source. Great quality and tons of info regarding technical service for the Technics SH8065.
;
5 stars on this manual since it is the complete version, not the half manual you find free for download all over the web. Good job.
KV-PG21P40/PG21M70/PG21P70
2-7. PICTURE TUBE REMOVAL Note:
� Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom right and left.
� REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
!� Cushion (50x550) DGC 8 Demagnetic coil !¡ Holder DGC
� REMOVING PROCEDURES
RM-952
!£ Cushion (35x250) DGC
a a 1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
7 Chassis assy 4 Four screws (washer head) (BVTP 3 � 12) 2 CV board 5 Deflection yoke 3 Speaker (5 � 9cm) !º Two screws (Tapping 5+ Crown Washer) 6 Tension spring 9 Two screws (Tapping 5 + Crown Washer)
A Board
b b
12 �
Coating earth assy CRT Support Block !� Picture tube
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
c
1 Anode cap
Anode button
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the
Screw Location
arrow c.
�
HOW TO HANDLE AN ANODE-CAP
CRT Support Block
1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
Slim Beznet !¢ Cushion
|
|
|
> |
|
