|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
KV-XJ29M31/XJ29M50/XJ29M60/ XJ29M80/XJ29M81
Using Your New TV
Getting Started
Step 1
Connect the antenna
If you wish to connect a VCR, see the Connecting a VCR diagram below.
Rear of TV
Notes � If you connect a monaural VCR, connect the yellow plug to (the yellow jack) and the black plug to -L (MONO) (the white jack). � If you connect a VCR to the 8 (antenna input) terminal, preset the signal output from the VCR to the program number 0 on the TV. � Do not connect video equipment to the t 2 (video input) jacks at the front and the rear of your TV at the same time; otherwise the picture will not be displayed properly on the screen (KV-XJ29M31/XJ29M80 (E)/ XJ29M50/M80 (India)/XJ29M50/M60 (Thailand)). � When no signal is input from the connected video equipment, the TV screen becomes blue. CAUTION � Do not connect the power cord until you have completed making all other connections; otherwise a minimum leakage current might flow through the antenna and other terminals to ground. � To avoid battery leakage and damage to the remote, remove the batteries from the remote if you are not going to use it for several days. If any liquid that leaks from the batteries touches you, immediately wash it away with water.
Using Your New TV
RM-952
or
Antenna cable (not supplied) IEC connector (not supplied)
Antenna cable (not supplied) : Signal flow
Step 2
Insert the batteries into the remote
� 8 �
4
Connecting a VCR
To watch the video input, press t (see page 13).
Rear of TV Antenna cable (not supplied)
Note � Do not use old batteries nor use different types of batteries together.
Step 3
Preset the channels automatically
Front of TV
To antenna output
VCR
1
To 8 (antenna
R L Y CB CR
2
AUTO PROGR
1
1
AUDIO VIDEO R VIDEO IN VIDEO OUT L
input)
VHF LOW B/G
To video and audio outputs
To t 1 or 2 (video input) Audio/Video cable (not supplied)
(yellow) -L (MONO) (white) -R (red) : Signal flow
Tips � If you want to stop automatic channel presetting, press SELECT twice. � If your TV has preset an unwanted channel or cannot preset a particular channel, then preset your TV manually (see page 10). Note � During automatic channel presetting, your TV screen will indicate �B/G� , �I�, �D/K� or �M� for the TV system (KV-XJ29M50/M80 (India)/ XJ29M80 (E/ME)/XJ29M50 (Thailand)/XJ29M81). Using Your New TV
Using Your New TV
5
|
|
|
> |
|
