|
There are currently no product reviews.
 ;
Scan quality is very good. Price is very reasonable. If you're looking to purchase a copy of this manual, this is the one to get.
 ;
Perfect for my use.Could have better pictures,but otherwise perfect ;)
;
This is one of four manuals I have downloaded recently.
Purchase was very straight forward and the authorising email arrived in about 4 hours.
The quality of the scan is good. Print is clear and square to the page edges.
;
Exactly as advertized. High quality digital copy of the Nak 610 user manual. Easy download and access. Highly recommended.
;
The manual was exactly what I wanted and I found it nowhere else. Thanks!
Note: If you do not fill with solder and directly cut the IC lead with the cutter, stress may build up directly in the P.C.board�s pattern. If you do not fill with large quantities of solder as in step 1 the P.C.board pattem may be removed.
2. Using a cutter, cut the lead at the source. (Cut the contents with the cutter lightly 5 or 6 times.)
3. Remove when the solder melts. (Remove the lead at the same time.)
After removing the Flat IC and when attaching the new IC, remove any of the excess solder on the land using the soldering wire, etc. If the excess solder is not removed from the land, the IC will slip and not be attached properly.
11.3. FLAT PACKAGE IC INSTALLATION PROCEDURE
22
|
