|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
KX-TC1493CB / KX-TC1493CW
18 HOW TO REPLACE FLAT PACKAGE IC
1 8 . 1 . Preparation
· SOLDER Sparkle Solder 115A-1, 115B-1 or Almit Solder KR-19, KR19RMA · Soldering iron Recommended power consumption will be between 30 W to 40 W. Temperature of Copper Rod 662 ± 50°F (350 ± 10°C) (An expert may handle between 60 W to 80 W iron, but beginner might damage foil by overheating.) · Flux HI115 Specific gravity 0.863. (Original flux will be replaced daily.)
iron as shown in below figure.
1 8 . 2 . Procedure
1. Temporary fix FLAT PACKAGE IC by soldering on two marked 2 pins.
*Most important matter is accurate setting of IC to the corresponding soldering foil. 2. Apply flux for all pins of FLAT PACKAGE IC.
3. Solder employing specified solder to direction of arrow, as sliding the soldering iron.
1 8 . 3 . M odif ic a t ion Procedure o f Bridge
1. Re-solder slightly on bridged portion. 2. Remove remained solder along pins employing soldering 47
|
|
|
> |
|
