|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Useful Information
Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset. Problem w is flashing. Cause & solution L The handset is too far from the base unit. Move closer. L The AC adaptor is not connected. Check the connections. L You are using the handset or base unit in an area with high electrical interference. Place the handset and base unit away from interference sources, such as antennas and mobile phones. L The handset registration is cancelled. Register the handset to the base unit using the following method.
1 2 3 4 5
{j/OK} �SETTING HS� i {>} �REGISTRATION� i {>} �REGISTER HS� i {>} Press and hold {x} on the base unit for about 5 seconds. L If all registered handsets start ringing, press {x} to stop, then start again from step 1. L The rest of the procedure must be completed within 1 minute. i {>}
6 Press {e} or {v} to select a base unit number. 7 Wait until �BS PIN� is displayed. i Enter base
unit PIN (default: �0000�). i {>} L If you forget your PIN, consult your nearest Panasonic service centre. L A confirmation tone will sound, and w will stop flashing. L If w is still flashing, start again from step 1.
The unit does not ring. The handset display is blank. The handset will not turn on.
L The ringer volume is turned off. Adjust the ringer volume (page 11). L The handset is not turned on. Turn the power on (page 6). L Make sure that the batteries are installed correctly (page 6). L Fully charge the batteries (page 6).
17
|
|
|
> |
|
