|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
 ;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
 ;
This service Manual for my JVC AV29BF10EES is very helful. Everything is show in detailed diagrams!!!! If you need really good source of information for this type JVC you are on the right place. I am satisfied and very glad for this excellent book. Thank you.
 ;
Great service, great value like always!!!
Some of the writing is a bit blur but all is usable.
A+++++++++++++++++
 ;
Great service manua!
Always great value and fast service A++++++++++++++++++
2-2-4. Video input adjustment
1. Input All white 90 IRE signal of NTSC to the video input terminal. 2. Select Video Calibration from the AD Converter menu. 3. Adjust the Sub Contrast (Video) and then, adjust the detection values of G to the set value. Detection set value: 230 ± 3 4. Set the video input signal to All gray 20 IRE signal of NTSC. 5. Adjust the Sub Bright (Video) and then, adjust the detection values of G to the set value. Detection set value: 51 ± 3 6. Adjust the CB Offset (Video) and then, adjust so that the detection value of B is the same as G value. 7. Adjust the CR Offset (Video) and then, adjust so that the detection value of R is the same as G value. 8. Repeat step 5 to 7 until the detection set value in step 5 above is obtained. 9. Repeat step 3 to 8 until the detection set value in step 3 and 5 above are obtained.
2-2-5. Video coder input adjustment
1. Input All white 30 IRE signal of SECAM to the video input terminal. 2. Select By Adj from the Chroma decoder menu. 3. Adjust the By Adj (SECAM) and then, adjust so that the detection value of B is the same as G value. 4. Select Ry Adj from the Chroma decoder menu. 5. Adjust the Ry Adj (SECAM) and then, adjust so that the detection value of R is the same as G value. 6. Repeat step 3 to 5 until the detection values of R, G, and B reach the allowable error range. Allowable error ± 5 7. Set [Cal Mode] to [OFF] after the A/D calibration adjustment is completed.
KZ-42TS1U(U/C)
2-3
|
|
 |
> |
|