|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
CHAPTER 5 TROUBLESHOOTING
B. Mechanical system
1. Adjustment at the time of replacement of major parts
Major parts Bin, bin roll Stapler swing unit*1 Lead cam *1 Stapler sorter only. Adjustment 1) Adjustment of bin roll height 2) Adjustment of guide bar parallelism*1 3) Adjusting the Position of the Guide Stopper*1 4) Adjusting the Position of the Load Detecting Switch
Table 5-102 2. Adjusting the bin roll height The dummy roll is designed to be eccentric at the bottom to allow the bin roll height adjustment. The height of touch point between the lead cam end and bin roll can be adjusted. After replacing or changing the positions of the bin rolls, check for the standard dimensions. Change the dummy roll bottom fitting angle if required for adjustment. 1) Adjusting method Keep the bin unit upright, and measure the distance between the dummy roll upper [1] an the bin roll [2]. If the gap is too large, remove the dummy roll lower [3] once and turn it counterclockwise; if the gap is too small, turn it clockwise. Then, mount it so that it is closest to 91.0 mm.
[2]
[1] [1]
91 0.3mm
[2]
[3]
Figure 5-111
5-8
COPYRIGHT © 1998 CANON INC. CANON STAPLER SOTRER-L1 MS-C1 REV.0 NOV. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
|
|
|
> |
|
