Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Text excerpt from page 38 (click to view)
Something not working?
Problem
Possible cause
Solution
The water tap is closed (E10). Open the water tap. The water inlet hose is squashed or kinked (E10). The machine does not fill Check the whole length of the hose and remove the kink.
The small filter of the water Clean the filter. inlet hose is clogged (E10). The door is not properly closed (E40). Close the door. Place the hose at the right height (see Installation section). Check the whole length of the hose and remove the kink.
The machine fills then empties immediately
The end of the drain hose is too low.
The drain hose is squashed or kinked (E20).
The machine does not empty and/or does not spin The RINSE HOLD option (stop with water in drum) has been selected.
The drain pump or the Clean the pump or check drain hose are clogged (E20). the hose. Empty out the water by pressing the START button or selecting the DRAIN programme.
The laundry is not evenly Redistribute the laundry distributed inside the drum. manually in the drum. Too much detergent has been used. An unsuitable detergent has been used that creates too much foam. One of the connectors on the water inlet hose is There is water on the floor leaking. The drain pump has not been properly screwed on after cleaning. Measure detergent according to the manufacturer�s instructions. Use a suitable washing machine detergent. Check that the hose is firmly screwed on at both ends. Fully screw the pump into place.
The cap on the emergency Replace the cap on the emptying hose has not been emergency emptying hose replaced after cleaning the after cleaning the pump. pump.