I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
Text excerpt from page 39 (click to view)
Something not working?
Problem
Possible cause
Solution Replace the fuse.
The main electrical fuse or the fuse in the plug has blown. The door is not properly closed (E40). The machine does not work The plug is not connected. The START button has not been pressed. The DELAYED START option has been selected.
Close the door; the click of the lock should be heard. Insert the plug. Press the button. Check the selected delay on the display.
The water tap is closed (E10). Open the water tap. The water inlet hose is Check the whole length of the squashed or kinked (E10). hose and remove the kink. The small filter of the water Clean the filter. inlet hose is clogged (E10). The door is not properly closed (E40). The machine fills then empties immediately The end of the drain hose is too low. Close the door. Place the hose at the right height (see Installation section). Check the whole length of the hose and remove the kink. Clean the pump or check the hose. Empty out the water by selecting the DRAIN or SPIN programme.
The machine does not fill
The drain hose is squashed or kinked (E20). The drain pump or the The machine does not drain hose are clogged (E20). empty and/or does not spin The RINSE HOLD option (stop with water in drum) has been selected.
The laundry is not evenly Redistribute the laundry distributed inside the drum. manually in the drum.
