|
|
|
Who's Online
There currently are 5758 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
2. Select water temperature l Match the water temperature to the type of fabric and soils being washed. l The top temperature is the wash selection and the bottom temperature is the rinse selection. NOTE: Use warm water with the PERMANENT PRESS or SHORT Cycles. For heavily soiled permanent press or knit clothes, pre-wash or presoak before washing in warm water. 3. Select cycle and wash time Start the washer l Push in the Cycle Control Knob and turn it clockwise. l Stop when the indicator on the knob�s outer ring points to the number in the wash cycle you want. The numbers are minutes of wash time. l Start the washer by pulling out the Cycle Control Knob. The washer will fill to the selected water level with the selected wash water temperature. After filling, the washer will agitate for the selected number of minutes. l To stop the washer at any time, push in the Cycle Control Knob. To restart the washer, pull out the Cycle Control Knob.
What happens in each cycle
Each cycle has been designed for different kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH agitation time. When the Cycle Control Knob is set to a number and pulled out, the washer fills before agitation and timing starts. After agitation starts, the knob turns clockwise until it points to OFF and the cycle ends. The washer will pause briefly through-out each cycle. These pauses are normal. They allow for the reversing of the motor, normal washer operation and the cool-down portion of the PERMANENT PRESS Cycle. 5
|
|
|
> |
|
