|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Before You Call (continued) ..............................
Check these )oints if your washer...
....
� Unevenly distributed load. Redistribute the load, close the lid and pull knob out. Check for leveling. Be sure water level is acceptable for load size. � Plug cord into live electrical outlet. � Check fuse or reset circuit breaker. Stops � Turn the control knob to proper cycle and pull knob out to start the washer. � Close lid and pull knob out to start the washer. For your safety, washer will not agitate or spin unless lid is closed. � This may be a pause or soak period in the cycle. Wait briefly and it may start. � The washer is equipped with a lid switch failure detector. If the lid switch should malfunction, the detector will stop fill operations for your safety. Call for service.
� � , ,.... .... .. � � � ............... .... .... � ..... � .. � ,.... � � �
�*
e.
e.
�
�
Leaks Water
� � � �
Make sure hose connections are tight. Make sure end of drain hose is correctly inserted and secured to drain facility. Avoid extended soaking - soak for 30 minutes or less. Avoid overloading.
Is Noisy
� � � �
Be sure washer is leveled properly as outlined in installation manual. Weak floors can cause vibration and walking. Be sure rubber feet are installed on leveling legs. A clicking sound may be the LoadSensor TM agitator as it moves the load down through the cleaning zone for maximum cleaning effectivness. This sound will vary from load to load. This is normal. � Operating sounds will vary depending on agitation speed.
Fills with the Wrong Temperature Water
� Turn both faucets on fully. � If equipped with a temperature selector knob, be sure it is set directly on a temperature setting and not between settings. � Make sure temperature selection is correct. � Make sure hoses are connected to correct faucets and inlet connections. Be sure water supply is regulated correctly. Flush water line before filling washer. � Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot water at the tap. Also check water heater capacity and recovery rate. � Disconnect hoses and clean screens. Hose filter screens may be plugged.
Forfurther assistance contact Maytag Appliances Sales Company, Maytag Customer Assistance: U.S. 1-800-688-9900or Canada 1-800-688-2002 U.S. customers using TTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080. 9
|
|
|
> |
|
