thanks for this download i got a pioneer bdp-lx70a blu-ray player and it had no manual i search everywhere on the internet and came across owner-manuals.com and i found that it was so easy to find and downloaded from this site if i ever need a manual again this would be the first place that i would come too thanks guys
I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
Text excerpt from page 30 (click to view)
...Water runs out from under the machine ? Is the inlet hose connector loose ? Is the hose clamp on the discharge hose loose ? Is the discharge hose damaged ? Is the lint filter cover properly closed ? ... The wash results are not as usual ? Was the wrong quantity or the wrong detergent added ? Insufficient detergent leads to grey washes and scale deposits in the machine. Check the quantities more exactly. Were special stains pre-treated ? Were programme and temperature correctly chosen? ... Despite pre-treatment, stains are not removed ? They may be stains which cannot be removed by washing. Ask a specialist. ... Grey traces are found on the finished wash ? Too little detergent was used for articles stained by ointment, grease or oil. The quantity of detergent is insufficient to dissolve grease ? Was the temperature chosen too low ? ... Traces of fabric softener are found on the finished wash ? In such cases, usually fabric softener, in particular in concentrated form, has gone directly into the wash outside of the machine. Such spots should be washed out as quickly as possible. ... At the end of the programme, there are white detergent deposits on the wash ? It is usually a case of insoluble elements of modern detergents. They are not the result of insufficient rinsing. Possible solution: brush out or shake out, or turn articles inside out for washing. ... After the final rinse cycle, suds are still visible ? Modern detergents can cause suds even in the last rinse cycle, but this has no influence on the rinse results. ... The wash is not spun sufficiently and there is water remaining in the drum ? Is the discharge hose bent ? Has the maximum height of the discharge hose of 1m been exceeded?
62
