Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Text excerpt from page 27 (click to view)
Operating Instructions
What to do when�
3
The whistling noise when spinning may be different to your prevous washing machine which is due to the modern drive system.
Trouble Shooting
If you call out an engineer and the fault is listed here, a charge is levied even if the appliance is in guarantee.
Fault Possible cause The mains plug is not connected. Washing machine does The fuse of the household not work. electrical system is faulty. Appliance is not switched on. The door is not closed properly. The machine does not take in water. The water tap is closed. The inlet hose is blocked. Remedy Plug in the mains plug. Replace the fuse. Switch on the appliance (pull out program selector). Close the door; you must hear a click as it locks. Open the water tap. Unscrew the hose from the tap, remove the filter and clean it under flowing water. Adjust the feet according to the installation and connection instruction.
The machine is not level.
Washing machine vibrates during operation or is unstable.
There is very little washing in This does not affect the the machine (e.g. only a bath functioning of the machine. robe). Water could not be completely pumped out before the spin because there is a kink in the outlet hose or the drain pump is blocked. Check that the outlet hose is correctly laid and if applicable eliminate the kink or clean the drain pump and if necessary remove any foreign bodies from the pump housing.