I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 15 (click to view)
How to wash
How to wash
Door seal
Check from time to time the door seal and eliminate eventual possible objects that could be trapped in the fold.
Emergency emptying out
If the water is not discharged (pump is blocked, filter or drain pipe are clogged), proceed as follows to empty out the machine: � pull out the plug from the power socket; � close the water tap; � if necessary, wait until the water has cooled; � place a bowl on the floor; � put the drain hose end into the bowl and let the water out. Should it not be possible to have access to the drain hose because, for example the appliance is built in the kitchen furniture, slightly loosen the drain filter after placing a bowl on the floor to let the water come out slowly. At the end screw the filter again.
Drain filter
The drain filter collects threads and small objects inadvertently left in the laundry. Check regularly that the filter is clean. Open the filter door. Place a container under the filter and unscrew it; some water will come out of the filter. Pull out the filter. Clean the filter under a running tap, then refit it, screwing it fully in.
Frost precautions
If the machine is installed in a place where the temperature could drop below 0°C, proceed as follows: � Close the water tap and unscrew the water inlet hose from the tap. � Place the end of the drain hose and the inlet hose in a bowl placed on the floor. � Select the �DRAIN� programme �D� and run it until the machine stops. � Turn the programme selector dial to X (RESET). � Switch the machine off. � Remove the plug from the power socket. � Screw the water inlet hose back on and put the drain hose back in its place. By doing this, any water remaining in the machine is removed, avoiding ice forming and consequently damage to the appliance. When you use the machine again, make sure that the ambient temperature is above 0°C.
Water inlet filter
If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked. Turn off the water tap. Unscrew the hose from the tap. Clean the filter with a stiff brush. Screw the hose back onto the tap.