Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 32 (click to view)
Electrical Connection
� The wire coloured green and yellow must be connected to the terminal marked with the letter �E� or by the earth symbol or coloured green and yellow � The wire coloured blue must be connected to the terminal �N� or coloured black. � The wire coloured brown must be connected to the terminal marked �L� or coloured red. � Upon completion there must be not cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
1
WARNING: A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely.
Permanent connection
In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point.
Positioning
To ensure correct operation: � The appliance must be level. Use a spirit level if necessary and adjust the feet to compensate for any unevenness in the floor. � The surrounding area must be kept clean, free of dust and fluff. � Do not install the appliance where the temperature may fall below freezing or rise above 35 °C. � Do not install the appliance on deep pile carpets or obstruct the front ventilation grille, as this will affect the air circulation and could lead to a build-up of heat which would adversely affect the operation of the machine.
