|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
- IMPORTANT SERVICE SAFETY PRECAUTION
- SPECIFICATIONS
- PART NAMES
- DISASSEMBLY OF THE SET
- ADJUSTING PROCEDURE OF EACH SECTION
- INTEGRATED CIRCUIT TERMINAL ARRANGEMENTS
- TROUBLE SHOOTING
- CHASSIS LAYOUT
- SCHEMATIC DIAGRAM
- BLOCK DIAGRAM
- PRINTED WIRING BOARD ASSEMBLIES
- REPLACEMENT PARTS LIST
- PACKING OF THE SET
There are currently no product reviews.
 ;
Complete original Service Manual in good (scan) quality!
;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
 ;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
LC-121M2E LC-150M2E
16 BELL f0 adjustment 1. Connect the oscilloscope to TP2851.
LC-121M2E LC-150M2E
1. Adjust BELL f0 so as to minimize the a-level.
17
Brightness adjustment (SECAM)
1. Input the standard colour bar signal (the same pattern as that of E-10CH) of SECAM into AV1. 2. Connect oscilloscope to TP821 (IC803, pin7, G output).
1. Adjust SECAM BRIGHTNESS, and adjust the black level of G output to DC 1.5±0.05V.
18
Unicolor adjustment (SECAM)
1. Input the standard colour bar signal (the same pattern as that of E-10CH) of SECAM into AV1. 2. Connect oscilloscope to TP821 (IC803, pin7, G output ).
1. Adjust SECAM UNICOLOR, and adjust so as to get 100% white-black level video component equal to 2.3± 0.05Vp-p.
19
Colour level adjustment (SECAM)
1. Input the standard colour bar signal (the same pattern as that of E-10CH) of SECAM into AV1. 2. Connect the oscilloscope to TP820 (B output).
Adjust SECAM COLOR so as to get the colour bar signal blue amplitude (black level - peak level) equal to 2.0V ±0.05Vp-p.
20
Tint adjustment (SECAM)
1. Input the standard colour bar signal (the same pattern as that of E-10CH) of SECAM into AV1. 2. Connect the oscilloscope to TP820 (B output).
1. Adjust SECAM TINT so as to get the colour bar signal magenta amplitude (black level-peak level) equal to 1.7V ±0.05Vp-p.
14
|
|
|
> |
|
|
Parse Time: 0.828 - Number of Queries: 115 - Query Time: 0.348
