|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very nice and real Service Manual, I didn't thought it actually exist in the real world at all.
 ;
VERY NICE FOR COURTESY AND PRECISION!.
tHE SITE IS VERY IMPORTANT FOR ALL DEVICES
vERY GOOD
;
+++ Is is fine, that was what i looking for. Thanks! +++
;
A very good complete archive, i am very satisfied for document.
;
The Service Manual received was helpful. The electronic information is exactly what I needed.
LC-20S1E
ADJUSTING PROCEDURE OF EACH SECTION
The best adjustment is made before shipping. If any position deviation is found or after part replace is performed, adjust as follows.
Preparation for adjustments
Use the dedicated AC adaptor or stable DC power supply. LC-20S1E AC adaptor: UADP-A043WJPZ DC power supply: 12V 5.0A
1. Adjusting procedure
� Checker adjustment Power ON (Adjustment processing mode) � +B adjustment � Counter bias adjustment � TAMP (Contrast) adjustment � White balance adjustment
2. Entering the adjustment processing mode
There are the following two methods. � Setting the pin (81)(KEY4) or pin (82)(KEY5) of IC2001 (microprocessor) to GND, turn on the power. � A "POWER" key is made on with pushing an "TV/VIDEO" and "MENU" keys at the same time.(K of the inspection process mode is displayed by the upper left of the image plane.) � Next, "CH (�)" and "VOL (�)" keys are pushed at the same time.(It becomes the image plane of the adjustment process mode.).....When it is canceled, it is made to turn it off.(Even off in the "MAIN POWER" key, off with R/C are good.)
3. Key operation in the adjustment process mode
� The receiving channel UP/DOWN is performed with the "CH (ù)/(�)" keys. One push ... The UP/DOWN tuning is performed per channel. Continuous push ... The UP/DOWN search is performed until a next receivable station is found. � Various adjustments The adjustment is performed for each item by the "MENU", "Menu cursor", "CH (ù)/(�)" or "VOL (+)/(�)" keys (LCD TV set and remote control). � Adjustment item is chosen with the Menu cursor upward/downward keys. � The adjustment item makes a toggle operation with the �MENU� key input. (Next item) If the "MENU" key is input while the bottom item is selected, it moves to the top item on the next page. � Press the auto preset button on the remote controller in the adjustment process mode, and the top item of the next page will show up regardless of which item appears now. Page 1 � Page 2 � ... � Page 66 � Page 1 � Press the manual memory button on the remote controller in the adjustment process mode, and the top item of the same page will show up. � UP/DOWN of each adjustment vale selected is performed with the VOL (+)/(�) keys input.
12
|
|
|
> |
|
