|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
 ;
Great to be able to set channels again, on an old but stoll fine working TV
;
Good quality instructions manual. Very useful to me. Quick and excellent service from Owner-Manuals... Thanks !!!
;
Sono molto soddisfatto e, quando mi necessiterà, mi avvarrò nuovamente di questo servizio!
;
A comprehensive Operating and Service Manual. All schematics are complete and easy to read. The PCB drawings and complete parts list are very helpful. I would definitely recommend this manual.
Basic Operation (Continued)
Sound Volume
â� To adjust the volume
Changing Channels
You can select channels using Channel Select or CH ( )/( ).
� To handle the increasing number of channels available, this LCD TV set allows you to select up to 100 positions (Channels 0 to 99). One-digit and two-digit methods of selection can be used. Follow the procedure shown below to select channels.
� Press VOL (+) to increase the sound volume. The numerical value increases. VOLUME 50 � Press VOL (�) to decrease the sound volume. The numerical value decreases. VOLUME 10
â� Using Channel Select
To select a one-digit channel (e.g., Channel 5):
1 2
Press 5 of Channel Select. If �5-� is indicated and the picture does not change, press -/-- to switch over to the 1-digit select mode and press 5 of Channel Select.
1
PAL B/G
â� To mute the sound
� Press e (Mute) to temporarily turn off the sound. The MUTE mark is displayed on the screen.
To select a two-digit channel (e.g., Channel 15):
1
Press -/-- to set the 2-digit select mode.
--
2
� Press e (Mute) or VOL (+)/(�) to turn the sound back to the previous level. MUTE is automatically cleared when one of the following buttons is pressed: POWER, VOL (+)/(�) or e (Mute). VOLUME 10
Press 1 of Channel Select.
1-
3
Press 5 of Channel Select.
15
PAL B/G
NOTE � Complete this procedure within 4 seconds, otherwise the selection will not be made.
Changing channels with CH ( control.
Press CH ( 1�2�3 Press CH ( 3�2�1
)/(
) on the remote
) and the channels change in the order shown below: � . . . � 98 � 99 � 0 � 1 � 2 � 3 � . . . ) and the channels change in the order shown below: � 0 � 99 � 98 � . . . � 3 � 2 � 1 � . . .
â� Using A (Flashback)
� Press A to switch the currently tuned channel to the previously tuned channel. � Press A again to switch back to the currently tuned channel.
11
LC-22GA3MX_E_P10-11.p65 11 04.8.25, 7:48 PM
|
|
|
> |
|
