Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
Clear and easy to read. All details as expected. Price acceptable , and quick delivery.
Text excerpt from page 12 (click to view)
Preparation
Setting the Display on the wall
Using an optional bracket to mount the Display � You can ask a qualified service personnel about using an optional AN-37AG1 bracket to mount the Display to the wall. � Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall AN-37AG1 wall mount bracket. (See the bracket instructions for details.) About setting the Display angle
� You can set the Display on the wall up to 5 degrees forward when the speaker is attached and up to 20 degrees forward when the speaker is not attached. Do not set the angle outside those ranges.
5°
Vertical mounting
Angular mounting
CAUTION
� Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that results in accident or injury.
Setting the AVC System with the stand
How to install the AVC System vertically using the stand unit. � Use the supplied stand unit for installing the AVC System vertically in an upright position.
1
Stick each spacer to the stand as shown.
Stand spacer Bulge
2
Attach each cushion to the stand as shown.
3
Fit the stand to the AVC System.
Peel each spacer away from the paper and attach to the four bulging areas on the stand.
Peel each cushion away from the paper and attach to the four areas at the bottom.
Insert the stand into the AVC System, making sure that the thick and thin bulges of the stand align with the big and Stand cushion Attaching point small holes on the AVC System. Thin bulge
Bulge
Attaching point
Small hole Big hole
Thick bulge
4
Attach the stand using the stand screws as shown.
Stand screw
The AVC System installed vertically with the stand.
NOTE
� When mounting the AVC System vertically, always use the supplied stand. Be careful not to block vent holes when standing up directly on the floor or a flat surface as this can result in equipment failure. 12