|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
9. Maintenance
NOTICE: The product you have purchased contains the latest in highquality optical components. Like all products equipped with an optical function - like e.g. camera lenses, slide projectors and binoculars - these components are sensitive to polluted environments. Small contaminations like dust and smoke particles can easily attach to the surfaces of the optical components, degrading the performance and reducing the lifetime of the product.
Cleaning
7. While firmly holding the filter, gently remove any accumulated dust with a vacuum cleaner. 8. Replace the filter. Firmly press the filter edges in place. Check if the filter is firmly tightened by turning the cover upside down.
Caution! Switch off and disconnect the projector before cleaning. 1. When the cabinet is dusty, clean it by gently wiping with a soft cloth. 2. A chamois leather slightly moistened with water is sufficient for cleaning the housing. 3. Do not use cleaning agents as they may harm the housing.
Always keep the lens clean 1. When the lens is dirty or dusty, first blow the dust off and then gently wipe with a soft brush or lens cleaning paper. Never touch the lens with your fingers. 2. The lens is likely to become mouldy if left dirty. Cleaning the dust filter
9. Replace the cover.
PP
Important! Make sure to clean the dust filter regularly. 1. Press the Stand by On button to switch off the projector. � The standby indicator lights up red. 2. Wait until the cooling fan has stopped (about 3 minutes and disconnect the mains lead and all other cables. 3. Turn the projector over. Never place the projector on the side where the connections are located! 4. Press tab A and lift up the cover.
PP ALM
� � � �
Notes: We advise you to clean the filter every 100 hours. Operating the projector without filter or with a torn or damaged filter may seriously damage the projector. When the filter is damaged replace it with a filter of the same type (12 nc: 3122 434 01180). The projector power cannot be switched on again unless the filter holder is installed correctly.
L A M
A
TER FILTE
5. Turn the cover upside down. The filter is located on the cover underside. 6. Carefully remove the filter from the cover.
20
TER FILTE
|
|
|
> |
|
