|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
6. Maintenance
Lamp
Warning: Lamplife has almost expired It is suggested to have a spare lamp available. The lamp type is indicated in the user guide.
>
When operation time reaches the last 100 hours of the average lamplife, the message �Warning: lamplife has almost expired� will be displayed on the screen, each time the projector is switched on.The lamp indicator lights up orange.
AV Mute
Source
Menu
OK
The lamplife remaining can be checked using the OSD menu. 1 Press Menu. � The menu bar appears on the screen. 2 Use Cursor Control to move the cursor to �Settings�. Use Cursor Control to select �Lamp counter�. The remaining lamplife hours are displayed in the action window at the bottom of the screen. 3 �
Lamp Stand by Temp
Picture (previous) Start-up screen Lamp counter Auto standby Auto source Feedback
Display
Audio
Settings
Lamp 5 Hours Lamp counter shows the operating hours of the lamp. It is suggested to reset when a new lamp is inserted. To reset keep OK key pressed for 3 seconds.
�
Warning: Lamplife has expired It is suggested to change the lamp, to avoid sudden failure and to improve overall picture quality.
When the lamplife has expired, the lamp indicator lights up red and the message �Warning: lamplife has expired� is displayed on the screen.
Lamp Replacement
AV Mute Source Menu OK
dE
1
Switch off the projector and wait until the lamp has cooled down (about 5 minutes) before disconnecting the projector. Remove the mains lead from both projector and wall socket. The mains lead must be disconnected from the projector otherwise the lamp door cannot be removed. Turn the projector over. Never place the projector on the side where the connections are located! Push tab A to the right and remove the lamp door. When tab A is pressed the mains inlet socket will be partly closed. The lamp door therefore cannot be removed if the mains lead is not disconnected from the projector. Read the caution and warning labels on the lamp holder.
Lamp Stand by Temp
2 3 � 4
A
Philips Home Cinema Projector
English User guide Garbo
28
|
|
|
> |
|
|
Parse Time: 0.273 - Number of Queries: 134 - Query Time: 0.072
