|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I needed the manual immediately and I got it immediately. I couldn't find this manual anywhere else on the net. The site was easy to traverse, and the price was very reasonable. I'll definitely be back for any future needs.
 ;
I received a good service manual, with good resolution. Improve the instructions for the purchase because they are not well understood.
For the rest, so good.
Thanks Angel.
;
Very good documentation for the Grundig 2077 model (as well as similar 800/900/1000 series radios). The first two pages are a summary of reception specifications and output capability. The third page is the tuner dial indicator and dial cord routing diagram. the final ~5 pages are the schematics for the various models (including 2077). The scan quality of the schematics are good, adn can be easily read if zoomed in. The documents are in German, not English as stated. It would have been nice to have the tuning sequence and settings, and some trouble shooting materials... or component and wiring map.
;
Perfect like it was descriped, Perfect like it was descriped
;
Very good detail, all pages clear, exactly what I needed
(2) If LED terminals are not seen from the back of Front Panel Assy After the LED was replaced, adjust the brightness with the Unit Alignment Controller. (Refer to service manual JME-US30L)
2 Louver Note: When mounting the Louver, pass all LEDs through the holes in the Louver. Cutter Pliers 6 Pull off the LED. <Caution on mounting LED> . Do not confuse the polarity. . Mount the LED in the midway, apply RTV, then push it in completely. Note: When mounting the C board, apply RTV to the periphery of C board as a measure of waterproofing.
3 Cut off the periphery of C board with a cutter.
4 C board 5 Remove the solder and stretch leads straight.
1 Nine screws (+B3 x 8) Torque force to tighten the screws: 0.8 N.m ± 0.1
Note: Take away the urethane foam inside of the panel when cutting off the C board. Caution for Static Electricity to LED Cell The LED is very weak to static electricity, and a discharge of static electricity could shorten the LED life. Wear the earth bands when touching the LED or the connector of the LED cell to replace the LED cell or handle the unit.
1-6 (E)
LDU-3050/G3050
|
|
|
> |
|
