WHIRLPOOL LER7648PQ0
Owner's Manual

6. Select the desired Option. See �Dryer Cycle Descriptions� (separate sheet). 7. If desired, add fabric softener sheet. Use only ones labeled as dryer safe. Follow package instructions. 8. Push the START button.

To use the drying rack 1. Place drying rack in dryer. Style 1: Your drying rack has front legs. Slide rear pegs into the dimples on the back wall of the dryer. Lower the front legs to rest on the dryer opening. Style 2: Your drying rack does NOT have front legs. Do not remove the lint screen. Slide drying rack over the bottom of the dryer door opening. Push down to secure rack on frame. 2. Put wet items on top of rack, leaving space between items. Do not allow items to hang over the edge of the rack. Close the door. 3. Select a timed drying cycle and temperature, or an air cycle. Items containing foam, rubber, or plastic must be dried on a clothesline or by using an air cycle. Refer to the following table. 4. Start the dryer. Reset cycle to complete drying, if needed. Rack Dry Washable wool items (block to shape, lay flat on rack) Stuffed toys/pillows (cotton or polyester filled) Stuffed toys/pillows Foam rubber filled Cycle Timed Drying Timed Drying Air (no heat) Temp Low Low N/A Time 60 min. 60 min. 90 min.

Stopping and Restarting
You can stop your dryer anytime during a cycle.

To stop your dryer
Open the dryer door or turn the Cycle Control knob to OFF. NOTE: The Cycle Control knob should point to an Off area when the dryer is not in use.

To restart your dryer
Close the door. Select a new cycle and temperature (if desired). Push the START button.

Drying Rack Option
Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum turns, but the rack does not move. If your model does not have a drying rack, you may be able to purchase one for your model. To find out if your model allows drying rack usage and for ordering information, please refer to the front page of your manual or contact the dealer from whom you purchased your dryer. NOTE: The rack must be removed for normal tumbling. Do not use the automatic cycle with the drying rack.

DRYER CARE
Cleaning the Lint Screen
Clean the lint screen before each load. A screen blocked by lint can increase drying time. IMPORTANT:
s

Cleaning the Dryer Interior

WARNING

Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics. If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. Every Load Cleaning

s

Explosion Hazard Use nonflammable cleaner.

Style 1: 1. The lint screen is located on top of the dryer. Pull the lint screen toward you. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. 2. Push the lint screen firmly back into place. Style 2: 1. The lint screen is located in the door of the dryer. Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. 2. Push the lint screen firmly back into place. As Needed Cleaning 1. Wet both sides of lint screen with hot water. 2. Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup. 3. Rinse screen with hot water. 4. Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

Failure to do so can result in death, explosion, or fire.
1. Apply a non-flammable household cleaner to the stained area of the drum and rub with a soft cloth until stain is removed. 2. Wipe drum thoroughly with a damp cloth. 3. Tumble a load of clean cloths or towels to dry the drum. NOTE: Garments which contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside-out to prevent dye transfer.

5