|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Lint screen
The lint screen is inside the dryer drum, on the back wall. Clean it before each load. A screen blocked by lint can increase drying time. 3. Roll lint off the screen with your fingers. DO NOT rinse or wash the screen. Wet lint is hard to remove.
Pull straight out.
Squeeze body; pull cover off.
1. Use the finger holes to pull the lint screen straight out. 2. Lightly squeeze the body, as shown, while pulling the cover off.
4. Replace the cover on the body of the lint screen. 5. Push the lint screen straight back in until it clicks into place.
Lint removal
Lint can gather inside the dryer and create a FIRE HAZARD. this lint should be removed at least every 2 to 3 years, or more often, depending on dryer usage.
ELECTRIC
DRYERS
GAS DRYERS
eaning should
be done only by a qualified
person.
1. Remove back panel (electric) or lower access panel (gas]. 2. Avoid damaging wires, thermostats, funnel or igniter. 3. Remove lint from shaded area see art-with a soft brush or vacuum cleaner. 4. Replace panel; reconnect and re-level dryer.
|
|
|
> |
|
