|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
FINISH GUARDI~ Control
When yoi~ TE r It .icle to unload the tlr;er as :oor I:S It .sp wrinkles can set in Your dryer �1 -IS c: fea:Jre xlled FINIY- GUARD If ~1.x cj 3r t open the door wrthrn five mnutes after the dryer stops FINISH GUARD token over cutomatically The FlNISt- �>UA .�C :-,ontrol tumbles the load, Lvi+hout p,ect, even/ five mrnutes Thus tumbllny rearranges and fluffs the load to help cvcrd wrrnkles caused by a load slttirg in a warm dryer The end-of !.:\i,~e slgnal WI/! beep after every FINISH GJARD tumbling. The tumbling WIII go on for 29 hours unless you open the mdrver door Indicator lights �~11 stay on OS long as FINISH GUARCS �s tumbling the load If you don .vcr�- :he FINISH GUARD option at the end of the dn/ing cycle, touch FINISt-1 GUA7D when you start the dryer (or cnyt�me �during c drying cycle] If you touchac FINISH GUARD �c cancel it, and then change your mint touch FINISH GUARD again
�he signal also beeps every the FINISH GUARD Control tumbles
time the
load. And it beeps If you turn the POWER SWITCH to ON and don�t touch a FABRIC-TEMP SELECTOR withrn eight seconds. The signal can�t be turned off and it IS not adjustable
lint Screen
The !rnt screen IS under the lid on top of the dryer C/eon the hnf screen before each load A screen that�s blocked by lint can cause longer drying times
End-of-Cycle Signal ~
:ld and
Tc remove the screen, pull the screen straight
open tne out. Roll
the lent off the screen with your fingers DO NOT rinse the screen or wash it. �Wet lint IS hard to remove When replacing the screen, push It firrnl~ into place Close the lid
Drum light
When the light inside the drum needs to be changed, you ccr reach I+ easrly through the dver door 1. Unplug the dryer tc avoid possible electrlcci shock 2. 3per the door and remove the �,ght bulb cover bq turnrng it clockK~se
A signal V. #I betit� i -e times to et you know the+ tr e .dn+er YIS stopped N* will not beep if )08j #.)pe: the drver door whl e the dryer 15KJno vg
The slgno 1~ r)? r?ft., Nhen you am
cQ;rg permaner t press i~~nthetlcs and c-ther Items iblat ~c~�~ should be tokrr~ out as sa r �0: +*-- :ver S+ODS
|
|
|
> |
|
