|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The purchased manual is an high quality scan of the original Philips paper-based Service Manual. I am very satisfied!
 ;
The purchased manual is an scan of the original Panasonic paper-based Service Manual. Unfortunately the contrast is not perfect, but I am satisfied anyway!
 ;
The purchased manual is an high-quality scan of the original JVC paper-based Service Manual. The Service Manual includes the Owner´s Manual, so you do not have to buy both of them.
 ;
It paid to find this Service Manual, couldn't find it anywhere else. Exactly what I wanted. Received within 24 hours.
 ;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
CHAPTER 4. TROUBLESHOOTING
No power supply
Does LED turns on in green when power switch is turned on? Yes
No
No output +5V, 12V from power supply unit.
Yes
Replace power supply unit.
LED turns on in red? No
Yes
* Check LED for breakage. * Check key cable for disconnection. Yes Replace any unit (main PWB, SW PWB, cable) which shows any defect, with a new one.
No Backlight turns ON? Yes LED turns on in orange? No Yes
Check whether the unit is in power save mode (synchronizing signal is not input.). 1) PC is turned off? 2) RGB cable is disconnected? 3) Synchronizing signal is output from RGB cable?
Check for RGB cable input signal. Normal Defective
Check each pin terminal of P3. Normal
No
Synchronizing signal is input to main PWB? Yes No Replace RGB cable with a new one.
A
Replace RGB cable.
* Check inverter PWB unit. Note: Use caution when checking output side because it has a high voltage. Normal Defective
Check power input system. 1) Power supply PWB * Normal? * Connected properly? 2) Blown out fuse (F1)? 3) Check +5VX, 3.3VX, 3.3VA, VDD, VD and VLCD are output? 4) LED * Check LED for breakage. * Check the path between P5 and U6. * Check the cable for disconnection. Yes
Replace inverter PWB unit with a new one.
Replace LCD module lamp with a new one.
Replace any defective unit. [ 1) Power supply PWB, 2) Main PWB, 3) Switch PWB ] with a new one.
LL-T15S3
TROUBLESHOOTING
4�1
|
|
 |
> |
|