|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Super manual it contains all the things you need to service your Marantz 2100.
;
A very easy to understand and use manual. Well worth the money.
 ;
Very good information with clear drawings. Thanks!
;
The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
;
Owner-manuals.com is the best Possibility to give vantage HIGH CLASS Elektronic COMPONENTS
a new Life.Thanks alot for your perfekt Service.
PC-UM10M
THE PC DISPLAY DOES NOT WORK. (DIGITAL DVI)
Does the display work normally with analog inputs? 4 (Yes) Is 14Pin of CN2 at DC+5V? 4 (Yes) Are the signal levels of 1PIN, 2PIN, 9PIN, 10PIN, 17PIN, 18PIN, 23PIN, and 24PIN of CN2 changed? 4 (No) Are the waveforms at 1PIN and 2PIN of IC7 changed normally when the resolution is changed? 4 (Yes) Check IC7and IC8. 3 (No) Check IC7 peripheral circuits. 3 (Yes) IIC8 abnormality 3 (No) Check CN2 and the signal source. 3 (No) First, check with analog inputs.
THE FIRMWARE CANNOT BE UPGRADED
Connected to the analog input CN1? 4 (Yes) Is SW1 set to 1, 2 side? (CN1 side when viewed from you) 4 (Yes) Is 2PIN of Q16 at the GND level? 4 (Yes) Are 1PIN and 13PIN of IC6 changed normally? 4 (Yes) Are signal waveforms provided at 12PIN - 19PIN of IC18? 4 (Yes) Check 31, 32, 33, 35, and 44PIN of IC15. (If there is no abnormality, IC15 or IC19 is defective.) 3 (No) ICheck IC18 and IC19 peripheral circuits. 3 (No) Check IC6 peripheral circuits. 3 (No) Check SW1 and R258. 3 (No) Set SW1 to 1, 2 side (CN1 side when viewed from you). 3 (No) Connect the jig fro rewriting the firmware to the analog input CN1.
AUDIO DOES NOT SOUND
Is the audio cable connected to CN2 of the AUDIO PWB? 4 (Yes) Is 1PIN of CN1 at DC+12V? 4 (Yes) Is the voltage at 2PIN of CN1 changed by varying the sound volume? 4 (Yes) Are 3PIN and 4PIN of CN1 changed to the GND level when any display is made? 4 (Yes) Is 5PIN of CN1 at the GND level? 4 (Yes) Replace the AUDIO PWB. 3 (No) Check CN1, the cable connected to CN1, and CN3 of the main PWB. 3 (No) Check IC20 and its peripheral circuits. 3 (No) Check IC15 and its peripheral circuits. 3 (No) Check Q15 of the main PWB and the AU12V power line. 3 (No) Connect the audio cable to CN2 of the AUDIO PWB.
LL-T1815 TROUBLE SHOOTING
4�5
|
|
|
> |
|
