|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was complete and of great quality. Originally a tri-lingual file, I first received only one language. After a note to owners-manuals.com, I quickly received the remaining languages... Great service, definitely worth it.
;
Thank you for providing this manual and at low cost.
The Philips scope is of excellent quality, longevity and build and had a couple of faults
when it was passed to me. Having the CCT diagrams is a blessing.
I have fixed the problems and also modded the scope to my requirements.
I have built a 24v Li-Ion pack for portable use from old but good laptop batts.
it is working beautifully and I am well pleased. Keep up the good work Guys.
 ;
manual was very helpful in learning how to propery use my washer. I could not find this manual anywhere else.
;
Awesome quality manual. You really saved my bacon with this one. Was looking for some specific information with regards to my "new" vintage VCR that didn't come with the owners manual. This site is truely a goldmine of available manuals. The quality of the scans are top notch.
Thank-you so much for this awesome manual. If you're looking for this Sony SL-HF400 owners manual, this is the one you NEED to buy. Definitely worth the money.
;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
English
� This lamp is designed for use with the Sony projector. � Be sure to confirm that this lamp is usable with your projector before using it by reading the Operating Instruction or Installations Manual for Dealers supplied with your projector.
3
Loosen the three screws with a Phillips screwdriver.
6 7 8 9
Tighten the three screws loosen in step 3 to secure the lamp unit to the projector. Replace the lamp cover and tighten the two screws. Replace the top panel and tighten the two screws. Connect the power cord and set the projector to standby mode.
About lamp replacement
Attaching the lamp may cause fire or injury to persons. Users should ask a qualified Sony representative to attach the lamp.
10Press the RESET, <, ,, and ENTER buttons on the
remote control in this order for less than five seconds each.
Replacing the lamp unit
Note � Before replacing the lamp unit, be sure to turn off the projector and disconnect the power cord of the projector. When replacing the lamp unit after using the projector, wait at least one hour to allow the lamp unit to cool. � Whenever you replace the lamp unit, be sure to replace the air filter with a new one. The illustrations below show the case of replacing the lamp unit with the projector installed on the ceiling. Disposal the used lamp The used lamp contains Mercury, dispose according to local, state or federal laws. As the materials used in this lamp are similar to those of a fluorescent lamp, you should dispose of a used projector lamp in the same way as a fluorescent lamp.
4
Holding the lamp unit with your hand, push back the stoppers on the left and right sides, then pull out the lamp unit.
Specifications
Dimensions 180 � 157 � 163 mm (7 1/8 � 6 1/4 � 6 1/2 inches) (w/h/d)
1
Loosen the two screws fixing the top panel at the rear of the projector using the supplied screwdriver (1), then slide the top cover backward and lift it to remove (2).
Mass 1.8 kg (3 lb 15 oz) Supplied accessories Screwdriver (1) Operating Instructions (1)
1
2
5
Insert the new lamp unit straight all the way in until it is securely in place, and pull out both the stoppers until you hear a click.
2
Loosen the two screws fixing the lamp cover using the supplied screwdriver to remove the lamp cover.
|
|
|
> |
|
