|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Came in the mail within a few hours. Gave clear instruktion on maintaines. Is of great use to have this manual in house
 ;
Easy to access. Clear instructions. No problems. Printed fine.
;
Great scan but please note that it is entirely in GERMAN.
;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
Adjusting the Satellite Speaker Position
LSF-1010 (EN)
17
Adjusting the Arm Angle
You can set the arm to any of five different angles by adjusting the angle of the arm holders.
2. Set the arm holders to the desired angle.
1 Take one of the arm holders, rotate it any of the angles A to E indicated at left, and place it back into the opening such that the corners of the arm holder match the ridges on the opening. � Please do not set the arm holders to any angle other than A to E. The speaker may not be stable (and is likely to tip over) if mounted at an angle outside of this range. 2 Loosely fasten the holder in place with the arm screw. � Don't tighten the screw all the way. Tighten only enough so that the arm holder stays in position at the selected angle. 3 Now set the other arm holder (the holder on the other side) to the same angle, and loosely fasten it with the arm screw.
1. Remove the arm.
Remove the arm.
FRAN�AIS DEUTSCH NEDERLANDS ITALIANO ESPA�OL
1 Loosen the two arm screws (one screw on each side of the arm) and pull the arm out. � Unplug the cord from the jack before removing the arm. 2 Loosen the two arm screws further to remove them from the arm holders.
Loosen the screws. At time of shipping, the arm is mounted at angle D.
3. Insert and fasten the arm.
1 Fit the arm through the openings in the arm holders and adjust to the desired height. Then tighten the two arm screws to lock the arm in place. 2 Replace the screw caps. 3 Reconnect the speaker cord to the jack.
Arm holders Remove the screws from the arm holders.
You may now want to readjust the angle of the speaker on the arm. You can do this by loosening the screw holding the speaker to the arm, repositioning the screw, and then retightening it. See �Adjusting the Speaker Angle, on page 8. �
|
|
|
> |
|
