|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am very happy with the owner's manual. I bought a used Casio and was so relieved that I was able to get a hold of a owner's manual. It was very easy to download the manual and I had no problems with printing it. Thank you! Nancy Whalen
;
The purchased manual is an high-quality scan of the original JVC paper-based Owner´s Manual. I am very satisfied!
;
Very satisfied with received document, all is right, Thank You very much, it was a Pleasure to work with You.
 ;
great site, the most easy and fastest way to find the manual you need, no 5 star because the manual was only available in german, but I speak german as well so no problem for me.
;
thanks for this download i got a pioneer bdp-lx70a blu-ray player and it had no manual i search everywhere on the internet and came across owner-manuals.com and i found that it was so easy to find and downloaded from this site if i ever need a manual again this would be the first place that i would come too thanks guys
SERVICE AND ADJUSTMENTS
� � Place �at washer and clutch spring on idler pulley bolt and secure with small retainer spring. Install belt onto engine pulley. FRONT-TO-BACK ADJUSTMENT (See Figs. 17 and 18)
IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-SIDE.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly in�ated (See �PRODUCT SPECIFICATIONS� section of this manual). If tires are over or underin�ated, you will not properly adjust your mower. SIDE-TO-SIDE ADJUSTMENT (See Figs. 15 and 16) � Raise mower to its highest position. � At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance �A� on both sides of mower should be the same or within 1/4" of each other. � If adjustment is necessary, make adjustment on one side of mower only. � To raise one side of mower, tighten lift link adjustment nut on that side. � To lower one side of mower, loosen lift link adjustment nut on that side. NOTE: Three full turns of adjustment nut will change mower height about 1/8". � Recheck measurements after adjusting.
BOTTOM EDGE OF MOWER TO GROUND
00598
To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position. Check adjustment on right side of tractor. Measure distance �D� directly in front and behind the mandrel at bottom edge of mower housing as shown. � Before making any necessary adjustments, check that both front links are equal in length. � If links are not equal in length, adjust one link to same length as other link. � � � To lower front of mower loosen nut �E� on both front links an equal number of turns. When distance �D� is 1/8" to 1/2" lower at front than rear, tighten nuts �F� against trunnion on both front links. To raise front of mower, loosen nut �F� from trunnion on both front links. Tighten nut �E� on both front links an equal number of turns. The two front links must remain equal in length. When distance �D� is 1/8" to 1/2" lower at front than rear, tighten nut �F� against trunnion on both front links. Recheck side-to-side adjustment.
MANDREL
01268
� �
BOTTOM EDGE OF MOWER TO GROUND
�A�
GROUND LINE
�A�
"D" "D"
FIG. 15
SUSPENSION ARM
FIG. 17
BOTH FRONT LINKS MUST BE EQUAL IN LENGTH
01553
LIFT LINK ADJUSTMENT NUT
01267
FIG. 16
NUT "F" TRUNNION
01156
NUT "E"
FRONT LINKS
FIG. 18
19
|
|
|
> |
|
