This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Text excerpt from page 12 (click to view)
Inserting batteries in the remote control handset
� Remove the battery cover located on the back of the handset by gently pulling downwards from the indicated part. � Insert two AA/R6 dry cell or equivalent type of batteries inside. � Replace the battery cover.
Switching the TV ON/OFF
To switch the TV on
Your TV will switch on in two steps: 1- Connect the power cord to the system. Press the On/Off switch at the rear of the TV. Then the TV switches itself to stand-by mode and the power lamp becomes red located on the front of the TV. 2- To switch on the TV from stand-by mode either: Press the � / I� button on the remote control or on the right side of the TV or, Press a digit button on the remote control so that a programme number is selected, or, Press � � or � � buttons on the remote control or on the right side of the TV, so that last switched off programme is selected. Either way the TV will switch on and the power lamp will become green.
NOTE: Remove the batteries from remote control handset when it is not to be used for a long period.Otherwise it can be damaged due to any leakage of battery. Old batteries must be disposed in a designated area. If performance of the remote control reduces, replace the batteries with the correct type. Do not combine a used, old battery or a new one or mixed battery types. Remove dead batteries immediately to prevent acid from leaking into the battery compartment.
To switch the TV off
NOTE: To switch the TV off completely, press the On/Off switch at the rear of the TV or remove the mains plug from the socket.
� Press the � / I� button on the remote control or on the right side of the TV, so the TV will switch to stand-by mode and the power lamp will become red.
