|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Quick response and exactly what I was looking for and at a great fair price!
;
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
;
So usefull to make my installation a breeze. 5 stars on quality.
;
very helpful, the information in these manuels are very detailed
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
2.2
Rear Panel
Pin No. 1 2 3 4
Signal GND (Y) GND (C) Y C
Rear panel
9
Video A terminals [VIDEO A IN/OUT] Video signal input (IN) and output (OUT) terminals The output terminal is bridge-connected (auto termination). IN : Video signal input terminal OUT : Bridge-connected video signal output terminal
12
Audio A, B, C terminals [AUDIO A, B, C IN/OUT] Audio signal input (IN) and output (OUT) terminals. The output terminal is bridge-connected. IN : Audio signal input terminal OUT : Bridge-connected audio signal output terminal
NOTE: For corresponding audio signals, use the AUDIO A terminals 12 .
10
NOTE: For corresponding video signals, use the VIDEO terminals 9 , 10 , 11 .
13
Video B terminals [VIDEO B IN/OUT] Video signal input (IN) and output (OUT) terminals. The output terminal is bridge-connected (auto termination). IN : Video signal input terminal OUT : Bridge-connected video signal output terminal
AC Inlet Power input connector. Connects the supplied AC power cord to the appropriate AC outlet.
NOTE: For corresponding audio signals, use the AUDIO B terminals 12 .
11
Video C (Y/C) terminals [VIDEO C Y/C IN/OUT] Y/C (S-Video) signal input (IN) and output (OUT) terminals. The output terminal is bridge-connected (auto termination). IN : Y/C-separated (S-video) signal input terminal OUT : Bridge-connected Y/C-separated (S-video) signal output terminal
Note: The impedance is automatically set to 75 � by the input of a signal on the input connector while operating in a single connection mode. However, if a cable is connected to the output connector, the connection is placed into the open status by the multiple connection and high impedance automatically selected. Do not leave an unused cable connected to the monitor. If a single cable is used, then it must be connected to the input connector for the 75 � auto termination selector to function properly.
NOTE: For corresponding audio signals, use the AUDIO C terminals 12 .
1.4
|
|
|
> |
|
