|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
remote control
1 Open the battery compartment. 2 Place the batteries in the
compartment with the correct polarity as indicated by �+� and �-� symbols. Close the cover. CAUTION! � Remove batteries if they are exhausted or will not be used for a long time. � Do not use old and new or different types of batteries in combination. � Batteries contain chemical substances, so they should be disposed off properly.
3
NTSC/PAL setting
Set the DVD system to NTSC or PAL, whichever matches your TV. The factory default setting is NTSC. This setting is necessary if you connected the DVD system to a PAL TV only.
1 Press SOURCE or DISC
to select disc mode. � Make sure that no disc is inside the disc tray.
Switching on the system
1 After completing all the connections, connect the AC
power cord of the DVD system and subwoofer to the power outlet.
2 Hold down DISC on the
PAL) appear on the display.
q The first time you turn on power, "AUTO INSTALL - PRESS PLAY" may appear on the display screen. Press� on the system to start � installation or press � to exit (refer to �Radio Reception Plug and Play�).
remote control until the current setting (NTSC or
3 If you want to change the setting, repeat step 2.
2 Press SOURCE button (or press TV/AV, DISC, TUNER
or AUX/DI) to select the input source. � The selected source will be displayed. q For viewing a DVD or VCD, a TV needs to be connected (refer to �Connections - Connecting a TV�). Switch on the TV and set it to the correct video in channel (for example, EXT1, EXT2, AV1, AV2). Refer to your TV instruction manual for details. � The default screen appears on the TV. q You can connect other equipment to the DVD system in order to use the Home Cinema Audio System�s surround sound capabilities. For example, connect to a TV and select TV/AV as the input source or connect to a VCR and select AUX as the input source.
PREPARATIONS
13
English
Inserting batteries into the
IMPORTANT! � If your TV screen is only showing a black/white picture or the picture is completely distorted, please refer to �NTSC/PAL setting� or �System Setup (DVD) - TV system�. � If you do not get a proper picture or sound, please refer to �System Setup (DVD)� in order to change the pre-settings as necessary to accommodate your TV system or change to your preferred settings.
|
|
|
> |
|
