|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Getting Started
Step 1: Inserting batteries into the remote control Step 2: Setting the TV
IMPORTANT! Make sure you have completed all the necessary connections. (See page 11 �Connecting TV�)
1 Press SOURCE control until �DISC�
appears on the display panel.
2 Turn on the TV and set to the correct 1 Open the battery compartment. 2 Insert two batteries type R06 or AA,
following the indications (+-) inside the compartment. video-in channel. You should see the blue DVD background screen on the TV. � Usually this channel is between the lowest and highest channels and may be called FRONT, A/V IN, VIDEO. See your TV manual for more details. � Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel. � Or, the TV remote control may have a button or switch that chooses different video modes.
Switching to YUV/RGB video output setting
3 Close the cover.
Using the remote control to operate the system
1 Aim the remote control
directly at the remote sensor (iR) on the front panel.
2 Press SOURCE button
on the remote to select the mode you wish to control (for example TV, DISC). The selected source mode will light up on the LED panel for a few seconds.
3 Then select the desired
function (for example �, S, T). CAUTION! � Remove batteries if they are exhausted or if the remote is not to be used for a long time. � Do not use old and new or different types of batteries in combination. � Batteries contain chemical substances, so they should be disposed of properly.
If the TV shows a blank screen or distorted picture, it may be due to the DVD system�s component video setting does not match with the video connection. You can change the component video setting between YUV and RGB as below:
1 Press STANDBY ON on the front
panel to switch on the DVD system.
2 Press OPEN/CLOSE 0 on the top
panel to open the disc tray.
3 Press 2 on the remote. 4 Press MUTE on the remote.
� You should see the blue DVD background screen on the TV.
19
001-047-LX83-22-Eng 19 6/9/04, 2:02 PM
3139 115 23271
E n g l i s h
|
|
|
> |
|
