|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
ED-X22EF (M1-20ED2)
Replacing the Lamp A lamp has �nite product life. Using the lamp for long periods of time could cause the pictures darker or the color tone poor. Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them. 1. Turn the projector off, and unplug the power cord. Allow the projector to cool for at least 45 minutes. 2. Prepare a new lamp. If the projector is mounted on a ceiling, or if the lamp has broken, also ask the dealer to replace the lamp. 3. Loosen the screw (marked by arrow) of the lamp cover and then slide the lamp cover to the side to remove it. 4. Loosen the 2 screws (marked by arrow) of the lamp, and slowly pick up the lamp by the handles. It may make it easy to take the lamp out slightly toward the control panel of the projector. 5. Insert the new lamp, and retighten firmly the 2 screws of the lamp that are loosened in the previous process to lock it in place. Tighten the screw 1 �rst, then screw 2 . 6. Slide the lamp cover back in place and �rmly fasten the screw of the lamp cover. 7. Turn the projector on and reset the lamp time using the LAMP TIME item in the OPTION menu. (1) Press the MENU button to display a menu. (2) Point at the �Go to Advanced Menu �� in the menu using the �/� button, then press the � button. (3) Point at the �OPTION� in the left column of the menu using the �/� button, then press the � button. (4) Point at the �LAMP TIME� using �/� button, then press the � button. A dialog will appear. (5) Press the � button to select �RESET� on the dialog. It performs resetting the lamp time.
The lamp cover
The handle
WARNING
�Do not touch any inner space of the projector, while the lamp is taken out. NOTE � Please reset the lamp time only when you have replaced the lamp, for a suitable indication about the lamp.
23
|
|
|
> |
|
