|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This service manual helped me to repair my PIONEER. Iam very satisfied, that I found it here.
Even the price of manual was not so high that person would not be able to spend a few money.
But that is very worth spent money. Thanks
 ;
Excellent quality service manual. Quick processing, fair prices. Love to do business again. Thank you!!!
;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
2-3
2-3
DISMANTLING INSTRUCTIONS
Dismantling the 3CDC Module 1) Loosen the 4 screws, slide Cover top (pos 30) towards the rear and remove it upwards. 2) Loosen 3 screws slide the Panel right (pos 26) towards the rear and remove it outwards. Do likewise for the Panel left (pos 27). 3) Push the gear slowly towards the front as shown in figure 3 until the CDC tray starts to move out of the Front Cabinet (pos 8). The CDC tray is now disengage and can be pulled out completely. 4) Remove the Cover Tray (pos 29) as shown in figure 2. 5) Loosen 4 screws A to remove the CDC Module (pos 28) as shown in figure 1.
Figure 2
A
Dismantling of the Panel Rear
A
1) Loosen 6 screws C on the Panel rear (pos 24). 2) Press the 2 catches C1 inwards and dismantle the Panel rear by pulling it towards the rear.
A
Turn the Gear towards the Front till the CDC Tray starts to open
Figure 1
C1
2 Pull Rear Panel out
1 Press Inwards
Figure 3
|
|
|
> |
|
