|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
CONNECTING AND OPERATING
HOW TO OPERATE IN SEPARATE CONNECTION MODE
2
5
1
4
You should begin with the power switched off.
1.
TURN THE OPERATION MODE SWITCH TO �SEPARATE� Make sure the power is switched off. If the power is on, the warning circuit will be activated, the mode illumination light and mode indicator will flash, and there will be no sound. TURN THE POWER ON Check to see that the word SEPARATE on the mode indicator has lit up. Note that it will not light up if the illumination button is switched off. ADJUST THE VOLUME ON THE CONTROL AMPLIFIER You should refer to the Directions for Use which came with the control amplifier.
2.
3. 4. 5.
USE THE ATTENUATOR DIAL TO ADJUST THE HIGHFREQUENCY CHANNEL VOLUME (0 to -15.0 dB) If you are not using the attenuator circuit, you should press the ATT THROUGH button for at least two seconds. The ATT THROUGH button will light up, and the sound will emerge after a delay of five seconds. SWITCH THE ATT HOLD BUTTON ON The ATT HOLD indicator will light up, and the adjusted attenuation will be held. If you wish to switch from ATT HOLD to ATT THROUGH, you should first switch the ATT HOLD button off, then press the ATT THROUGH button for at least two seconds.
15
OPERATION
|
|
|
> |
|
