|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
Radio Reception
English
Programming radio stations
You can store up to a total of 20 (10 FW and 10 MW) radio stations in the memory. Automatic programming Automatic programming will start with a chosen preset number 1. From this preset number upwards, former programmed radio stations will be overridden.
1
Press STOP/BAND (on the set) or TUNER (on the remote control) once or more to select your waveband. Press PRESET G / H (3 / 4 on remote control) to select the preset number where programming should start. Note: � If no preset number is selected, default is preset (1) and all your presets will be overridden.
2 Tuning to radio stations 1 2
Select TUNER source. � is displayed. Press STOP/BAND (on the set) or TUNER (on the remote control) once or more to select your waveband. Press on TUNING ¡1 or 2� and release button. � The radio automatically tunes to a station with sufficient reception. Display indication during automatic tuning Srch. Repeat step 3 if necessary until you find the desired station.
3
3
Press PROG for more than 2 seconds to activate programming. � AUto is displayed and available stations are programmed in order of waveband reception strength. Manual programming
4
1 2 3
Tune to your desired station (see Tuning to radio stations). Press PROG to activate programming. � PROG flashes in the display. Press PRESET G / H (3 / 4 on remote control) to select a number from 1 to 10 for FM (or 1 to 10 for MW) to this station. Press PROG again to confirm the setting. � PROG, the preset number and the frequency of the preset station is shown. Repeat the above four steps to store other stations.
� To tune to a weak station, press TUNING ¡1 or 2� briefly and repeatedly until you have found optimal reception. Helpful hints: To improve radio reception: � For FM, extend coil antenna at the back of the unit fully for optimum reception. � For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set.
4
5
� You can override a preset station by storing another frequency in its place.
14
|
|
|
> |
|
