|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a high quality manual with clear schematic and components layout diagrams ; with service procedure included.
 ;
This service manual for the Kenwood KT-990D was reproduced really well ,is very legible and manual is complete.Combined with the low price paid,in the future,I will be checking Owner-Manuals.com any time I need a manual.
;
When I purchased this manual I had my doubts regarding the quality as the price was so reasonable as compared to other outlets.
The manual itself is of high standard the print is very clear as are the diagrams. Obviously with the diagrams one has to zoom in otherwise it is to small to be able to read.
Overall I am very pleased with the company who delivered as they said and with the manual they supplied.
I occasionally require a manual and now having registered with this company I shall order from them in the future.
;
I was at first dubious about payiong for downloaded manuals but having done so, I was extremely impressed with quality of the two manual I ordered, well worth the small price I paid.
I would highly recommend these to my friends.
;
reasonable price for the schematic - the service is perfect, all as expected and pointed by instructions - good scan of the original plans - thank you!
2. ADJUSTMENT
The adjustment jobs should be done on a flat, plain surface.
2.1
Purge Unit Height Adjustment
Once you have removed the purge unit, you need to adjust the height of the purge unit relative to the carriage rail by using the purge unit adjustment jig (part of the special adjustment jig set). If you have also removed the printer frame ASSY first adjust the head-platen gap (see Sec, tion 2.2) and then proceed to the purge unit height adjustment. Purge unit adjustment jig The purge unit adjustment jig is as illustrated below.
Purge unit adjustment jig
Adjustment procedure (1) (2) (3) (4) Move the carriage to the left end of the carriage rail. Put the removed purge unit back into place, and then loosely fit the two fixing screws at the right hand side. Move the head cap to the right so that the adjustment jig can be fitted on the head cap rail and the carriage rail as shown below. (Put the hook between the head cap rail.) Turn the knob of the adjustment jig while pushing it down in order to clamp it on the CR base.
Adjustment jig
Knob
Head cap
IV � 57
|
|
|
> |
|
