|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Troubleshooting
RADIO RECEPTION Radio reception is poor. � If the signal is too weak, adjust the antenna or connect an external antenna for better reception. � Increase the distance between the Micro HiFi System and your TV or VCR.
TAPE OPERATION / RECORDING Recording or playback cannot be made. �CHECK TAPE� is displayed. The tape deck door cannot open.
� Clean deck parts, see �Maintenance�. � Use only normal (IEC I) tape for recording. � Apply a piece of adhesive tape over the missing tab space. � Remove and reconnect the AC power plug and switch on the system again.
GENERAL The system does not react when buttons are pressed. Sound cannot be heard or is of poor quality.
The left and right sound outputs are reversed. The remote control does not function properly.
� Remove and reconnect the AC power plug and switch on the system again. � Adjust the volume. � Disconnect the headphones. � Check that the speakers are connected correctly. � Check if the stripped speaker wire is clamped. � Check the speaker connections and location. � Select the source (CD or TUNER, for example) before pressing the function button ( , , ). � Reduce the distance between the remote control and the system. � Insert the battery with its polarities (+/� signs) aligned as indicated. � Replace the battery. � Point the remote control directly toward IR sensor on the front of the system. � Set the clock correctly. � Press TIMER ON / OFF to switch on the timer. � If a recording is in progress, stop the recording. � Power has been interrupted or the power cord has been disconnected. Reset the clock/timer.
The timer is not working.
The Clock/Timer setting is erased.
21
English
|
|
|
> |
|