ROLAND MC-505
Quick Start

®������®

MC-505
Groovebox It�s a Fact�
The MC-505 Groovebox builds upon the successfulMC-303 as a self-contained, retro-styled dance music sequencer and sound module with powerful new sounds and realtime controls. Features include: � High performance sound engine with 64-voice polyphony � Multi-mode resonant filters � Front panel ADSR envelope controls � Revolutionary D-Beam* controller for effects and sound/note control via hand movement over an infrared light beam � 714 onboard dance music patterns � 512 built-in sounds and 26 rhythm sets. � 3 independent effects processors � MEGAMIX function allows for intuitive pattern creation by combining rhythms and parts of one pattern with another � Enhanced MIDI implementation � 6 audio outputs � Low Boost circuit with octave control provides low end punch � Uses Smart Media cards for external pattern and patch storage (512 patches/200 patterns on a single card). Onboard sequencer capacity increased to 95,000 notes (up to 480,000 notes on a 4MB Smart Media card).

TurboStart
Playing Patterns
The MC-505 contains 714 onboard preset patterns. Use the following procedure to play these patterns. 1. 2. 3. 4. 5. 6. Press MODE so that the PTN indicator lights. Press PTN/SONG in the DISPLAY section. Press PRESET in the BANK section. Turn the VALUE dial to select the desired pattern. Press PLAY. While the pattern is playing, you can turn the VALUE dial to select the next pattern. Press STOP to halt playback.

Using the Mute Function
Use the following procedure to mute any Part of a Pattern while it is playing back: 1. Select a pattern and press PLAY. 2. Press PART MUTE so it�s lit. 3. Press the PART BUTTONS (R-7) to Mute the selected part. The PART BUTTON will blink. 4. Press the PART BUTTONS (R-7) again to activate the selected part.

Modifying Sounds in Realtime
Use the following procedure to modify the sound you are currently playing using the front panel controls: 1. Press PART SELECT so it�s lit. 2. Use the PART BUTTONS (R-7) to select a part. 3. Play the keyboard pads and the selected patch will sound. Use the OCTAVE (- / +) buttons to shift the patch down or up. 4. Turn the CUTOFF knob as you play the keyboard pads. 5. Experiment with the RESONANCE, LFO DEPTH, and PORTAMENTO knobs. 6. Now try changing the ENVELOPE A, D, S and R sliders. Note: You can use the same controls to modify a Part that is playing back in a Pattern.

�

Restoring Factory Settings
1. 2. Hold SHIFT and turn the power on. Press ENTER.

Note: The procedure takes approximately 4 minutes

Playing the Demo Songs
1. 2. 3. 4. 5. If the MC-505 is playing, press STOP. Simultaneously press EXIT and ENTER. Turn the VALUE dial to select a demo song. Press PLAY to start playback. Press STOP to end playback. Press EXIT to leave Demo Mode.

TBS72

© 1999 Roland Corporation U.S., 5100 S. Eastern Ave., Los Angeles CA 90040

Faxback # 20070

Page 1