I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Text excerpt from page 17 (click to view)
FM Radio Reception
� To tune to a weak station, press the control knob on the front panel of the system to the left or right (corresonding to S/T) or 5 /6 on the remote briefly and repeatedly until you have found optimal reception.
Programming radio stations
You can store up to a total of 20 FM radio stations in the memory. Automatic programming Automatic programming will start with from preset 1 and stop a the last programmed station. All the former programmed radio stations will be overridden.
1
Press PRESET -/+ on the top of the system or ¡ / � on the remote to select the preset number where programming should start. Note: � If no preset number is selected, default is preset (1) and all your presets will be overridden.
2
Press and hold the control knob on the front panel upward (corresponding to PROGRAM) or PROG on the remote for more than 2 seconds to activate programming. � AUTO is displayed and available stations are programmed in order of waveband reception strength: RDS followed by FM. The last preset automatically stored will then be played. Manual programming
Tuning to radio stations 1 2
Press SOURCE on the top of the system or FM on the remote to select FM. Press and hold the control knob on the front panel of the system to the left or right (corresonding to S/T) or 5 /6 on the remote. � The radio automatically tunes to a station with sufficient reception. Display indication during automatic tuning: SEARCH.
1 2
Tune to your desired station (see �Tuning to radio stations�). Press the control knob on the front panel upward (corresponding to PROGRAM) or PROG on the remote to activate programming. Press PRESET -/+ on the top of the system or ¡ / � on the remote to allocate a number from 1 to 20 to this station. Press the control knob on the front panel upward (corresponding to PROGRAM) or PROG on the remote again to confirm the setting. � The preset number and the frequency of the preset station are shown.
3 4
3
Repeat step 2 if necessary until you find the desired station.
