|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very quick response. Very good and accurate print quality of the scanned document.
 ;
The service manual was very usable and clear enough to see the individual values of all of the components (unlike some of the service manuals I have gotten in the past from web sites similar to this one). The price was right and the information was greatly appreciated. It helped me with an otherwise very difficult repair. It was much needed and appreciated. A faster turn around on my order would be nice, but I understand the constraints on your staff's time. Thank you for your service.
;
Excellent manual. Helped me out with disassembling and troubleshooting my projector.
;
thanks you are the best.Very good detail, Quick service response. A useful service manual with all details.
;
Great service!!! Polecam gorąco wszystkim zainteresowanym
MC-GG283-00
3 REPLACEMENT INSTRUCTIONS
3.1.
3.1.1.
Lower Plate
Removal
1. Place handle in low position. 2. Turn the vacuum cleaner over exposing the underside. Release the lower plate by pressing the two (2) latches that secure it inward. 3. Separate the lower plate from the vacuum.
2. Remove the lower plate as outline in Lower Plate remove / installation section.
3.1.2.
place.
Installation
3. Carefully lift up on the agitator assembly until it clear both sides of the nozzle housing.
1. Hook the front of the lower plate into the slots on the front of the nozzle housing. Press the lower plate down into 2. Fasten the lower plate by pushing the two (2) latches outward. NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical component or enclosure, the unit should be reassembled and checked for dielectric breakdown or current leakage.
3.2.
3.2.1.
Agitator Assembly
Removal
4. Remove the belt from the motor shaft by sliding it off between the end of the shaft and the nozzle housing.
1. The brushes are not replaceable separately. When the brushes need replacing, the agitator assembly will have to be replaced.
3.2.2.
Installation
1. Place the belt around the motor shaft.
10
|
|
|
> |
|
