|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual is very useful. Because pioneer sx-q180 is unhandy to use without manual.
;
Manual was destroyed and this purchase made it possible to recover my manual . It was easy to down load and smooth to use thanks .
 ;
Turns out this was not the manual i was looking for. The concertmate 670 keyboard i have is a "Realistic" model made for Radio Shack and none of the diagrams on the owners manual i received matches up. HOWEVER, I must say the service Owners Manual provides was fast and efficient by being available online. The manual was in good readable condition and easily downloaded.
;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
Thank´s for your help, I already recived these manual from you
Troubleshooting
RADIO RECEPTION Radio reception is poor.
E n g l i s h
38
� If the signal is too weak, adjust the antenna or connect an external antenna for better reception. � Increase the distance between the Micro System and your TV or VCR.
GENERAL The system does not react when buttons are pressed. Sound cannot be heard or is of poor quality.
The left and right sound outputs are reversed. The remote control does not function properly.
â�� Remove the AC power plug for one minute. Then reconnect and switch on the system again. â�� Adjust the volume. â�� Disconnect the headphones. â�� Check that the speakers are connected correctly. â�� Check if the stripped speaker wire is clamped into the speaker terminal. â�� Make sure the MP3-CD was recorded within 32-256 kbps bit rate with sampling frequencies at 16 kHz, 22.05 kHz, 48 kHz, 44.1 kHz or 32 kHz. â�� Check the speaker connections and location. â�� Select the source (CD or TUNER, for example) before pressing the function button (Ã�,Ã,ë). â�� Reduce the distance between the remote control and the system. â�� Insert the batteries with their polarities (+/- signs) aligned as indicated. â�� Replace the batteries. â�� Point the remote control directly toward the IR sensor on the front of the system. â�� Set the clock correctly. â�� Press TIMER ON/OFF to switch on the timer. â�� Press DIM to select DIM OFF display mode. â�� Power has been interrupted or the power cord has been disconnected. Reset the clock/timer.
The timer is not working. Not all buttons are lit. The Clock/Timer setting is erased.
Visit our website �http://My.Philips.com� for online help.
|
|
|
> |
|
