|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was very helpfull, it answerdes all my questions, and i was surprized to find the original manual on this site! Big thumbs uP:)
 ;
helpful manual.good service.Quick response.will use again
;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
;
I was searching for this manual at last i got it from this web
;
What can i say but i would have been lost without your support.
Thank You!
Preparations
Preparations
C
Speakers Connection Front Speakers Connect the speaker wires to the SPEAKERS terminals, right speaker to "RIGHT" and left speaker to "LEFT", the wire (marked red) to "+" and the wire (marked black) to "-".
Before using the remote control 1 2 3
Pull out the plastic protective sheet. Select the source you wish to control by pressing one of the source select keys on the remote control (for example CD, TUNER). Then select the desired function (for example Ã�, Ã, ë).
FM wire antenna
AM loop antenna
Speaker (right)
Speaker (left)
� Fully insert the stripped portion of the speaker wire into the terminal as shown. Notes: � For optimal sound performance, use the
AC power cord
Rear connections
The type plate is located at the rear of the system.
B Antennas Connection 1
AM (MW) antenna Unfold the loop antenna and if necessary, use screws (not supplied)to fix it to a flat, hard and stable place:
1
supplied speakers. � Do not connect more than one speaker to any one pair of +/- speaker terminals. � Do not connect speakers with an impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.
Replacing battery (lithium CR2032) into the remote control 1 Pull out the knob A slightly to the left. 2 3
Pull out the battery compartment B . Replace a new battery and fully insert the battery compartment back to the original position.
A B
A
Power � Before connecting the AC power cord to the wall outlet, ensure that all other connections have been made. WARNING! � For optimal performance, use only the original power cable. � Never make or change any connections with the power switched on.
2
2 3
Fit the plug of the loop antenna to AM ANTENNA as shown above. Adjust the antenna for optimal reception FM Antenna It is unnecessary to connect the FM pigtail antenna since it is fixed to the main unit.
� Position the antenna as far as possible from a TV, VCR or other radiation source.
CAUTION! Batteries contain chemical substances, so they should be disposed off properly.
9
10
|
|
|
> |
|
