|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Troubleshooting
WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help. Problem Radio reception is poor. Solution � If the signal is too weak, adjust the antenna or connect an external antenna for better reception. � Increase the distance between the system and your TV or VCR. � Insert a disc. � Load in the disc with label facing up. � Replace or clean the disc, see �Care and safety information�. � Use a finalised CD-R(W) or a correct format disc. � Remove and reconnect the AC power cord and switch on the system again. � Use only NORMAL (IEC I) tape. � Apply a piece of adhesive tape over the missing tab space. � Remove and reconnect the AC power plug and switch on the system again. � � � � Adjust the volume. Disconnect the headphones. Check that the speakers are connected correctly. Check that the AC power cord is connected properly.
E n g l i s h
�NO DISC� is displayed or the disc cannot be played.
The system does not react when buttons are pressed. Recording or playback cannot be made.
The tape deck door cannot open.
Sound cannot be heard or is of poor quality.
The remote control does not function properly.
� Select the source (CD or TUNER, for example) before pressing the function button (� , � S, T). � Reduce the distance between the remote control and the system. � Replace the battery. � Point the remote control directly toward the IR sensor. � Set the clock correctly. � Press TIMER ON /OFF to switch on the timer. � If recording is in progress, stop the recording. � Press and hold DEMO STOP on the main unit to switch off the demonstration mode.
The timer is not working.
The system displays features automatically and buttons start flashing.
22
|
|
|
> |
|
