|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The service was quick and simple, finding the service manual easy and it appears to be the original with colour schematics. It contained the info I was after and so sorted the problem.
I have copied it to CD and attached the envelope to the inside back cover of the owners manual. Good manual and excelent service. Robin Wood, Wood Electronics, New Zealand.
;
Exactly what was needed to assess the product - excellent value and great service
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
MC-UG585-00
and the plastic shaft, pry out the plastic shaft as illustrated.
3.5.2.
Installation
1. Install the window, furniture guard, and nozzle packing, if not already in place in the new nozzle housing. Remove plastic shaft, handle release assy, light bulb assy, and reflector. 2. Fit the nozzle onto the main body by sliding the nozzle housing between the frame and the main body on the motor shaft side and the headlight wire through the slot on the opposite side as illustrated. 6. Remove the nozzle housing by pulling off of main body as illustrated. Both sides are slotted, one to clear headlight wire and the other to clear the motor shaft.
3. Slide the plastic shaft through the nozzle housing and into the dust container. Make sure that the slot on the bottom of the plastic shaft is down and fitted onto the projection.
7. Remove the nozzle packing and furniture guard from the nozzle housing.
4. Replace the three (3) screws that secures the pedal assembly. 5. Replace the reflector, headlight assembly, and nozzle hose. The nozzle hose has a locator tab that fits into a slot in the main body. 6. Install the belt, agitator assembly, and the lower plate according to their respective instructions.
8. Remove the window by prying the two (2) locking tabs away from the nozzle housing and pushing out on the window. Remove plastic shaft, handle release assy, light bulb assy, and reflector. CAUTION: If the motor case cover is removed, DO NOT turn vacuum over as the motor may fall out.
12
|
|
|
> |
|
